Blade MAC 11 Kit

Here's the cool pistol from the first Blade movie! It also made an appearance in other ones as well. This one is done in all matte black PLA. You can keep it all blacked out, or paint it. The one in the pics has not been painted.

Includes a small springs for the trigger and for the magazine release so it's removable. As well as metal rods for them.

You’ll need super glue and some paint to complete it.

I'm offering it in 4 different styles:

 

Full Kit - Includes everything you need to build an awesome prop.

Full Kit with LED - Same as above but with the LED kit.

Add On - This is the option for people who already have a Mac 11 prop (probably an Airsoft) and want to upgrade it to the Blade Mac 11. I can’t promise that it will fit every airsoft or replica Mac 11 out there, but it should be able to fit with a little work.

Add On with LED - Same as above but with the LED kit.

 

Assembly for the Full Kit:

 

1- Glue the spring into the trigger and the mag release.

2- Insert the bar for the mag release. Glue it in place but be sure not to get any glue on the release lever.

3- Glue the mag well into place.

4- Glue the muzzle to the lower bar. You can also use the magnets if you want to be able to open it later.

5- Glue the compensator to the Mac body.

6- Glue the selector and the charging arm in place.

7- You can paint the bullets on the magazine if you want, or just pop in the mag and you’re ready to hunt some vampires!

 

For adding the LED, install it through the 3mm holes and use hot glue to hold it in place. Add the magnets to the lower and front muzzle. Use 2 AG13 batteries for the LED.

 

For the Add On Kit:

 

1- Remove the front sight.

2- Remove the rear sight and any stock that may be included.

3- Remove the trigger guard.

4- Either glue the lower to the front muzzle or use the magnets (if you're using the LED's).

5- Glue the top plate on.

6- Glue the mag well strip into place.

7- Place the front muzzle in place, either by gluing it or inserting it if the airsoft barrel kits.

8- You may have to cut the magazine down. Please do not cut it if it's a gas powered airsoft!

 

For adding the LED, install it through the 3mm holes and use hot glue to hold it in place. Add the magnets to the lower and front muzzle. Use 2 AG13 batteries for the LED.

 

Click here to see the instructions page:

https://youtu.be/Vx2D3gDYjK8

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: